Lambert spout
price:
$
285
- In stock
- Ships in 2-3 days
This is a hexagonal plate that squirts a flat stream of water. It works well in a swimming pool or spa where bumping into a longer spout might prove problematic. It's short projection also makes it safer around kids who might be tempted to use a longer spout as a handhold.
Quick facts
- Size
- 5 ⅛ in × 4 ½ in
- 1 in projection
- Material
- silicon bronze
- Plumbing
- ¾ in pipe size
- Arc length
- 6–30+ in
- see the flow profile
Available finishes
Available in the standard bronze finishes with either a wax or epoxy coating. More about the finishes and coatings is on the bronze finishes page
More technical info
Details
- Part is made of silicon bronze
- It is designed to be used with ¾ in plumbing. The casting is bored with a hole to accomodate ¾ in NPT pipe. The connection is a slip fit sealed with an o-ring. The pipe needs to be within 3° degrees of perpendicular to the wall the spout will be attached to - there is some wiggle room.
- A bonding lug for #8 AWG wire is provided at the back. A set screw at bottom of back plate secures the wire.
- Decorative use only. More secure mounting options available but they are expensive and complicated to install—call to discuss.
- The length the water shoots out of the spout is easily adjusted by varying the water volume supplied to the spout. Tagetting a landing zone for the water arc is a farly simple matter. The flow chart provides more information about this.
- Designed to be removable. Provided it's installed in a way that allows for this.
What's provided
- durable bronze casting
- ¾ in NPT socket connection
- two screw bosses with ¼-20 thread
- bonding lug for #8 AWG wire
- installation instructions
- o-ring grease
- hex wrench for bonding lug
- a lot of love ❤