Stubby Oona spout
price:
$
512
- In stock
- Ships in 2-3 days
This is a bronze spout with round pleasant lines sized for use in installations that might require a short water projection: a wall fountain with a narrow pond basin. However, it would also llok fantastic as a pools scupper. It has all the usual refinements. It's easy to install. It's available in a number of finishes And, it's beautiful.
Quick facts
- Size
- 5 ⅛ in diameter back plate
- 4 ⅞ in projection
- Material
- silicon bronze
- Plumbing
- 1 ½ in pipe size
- Arc length
- 6–11 in
- see the flow profile
Available finishes
Available in the standard bronze finishes with either a wax or epoxy coating. More about the finishes and coatings is on the bronze finishes page
More technical info
Details
- Part is made of silicon bronze
- It is designed to be used with 1½ in plumbing. The casting is threaded with 1½ in female NPT. A 1½ in male adapter is provided to screw into back of spout. If you have a piece of PVC pipe sticking out from the wall you could just glue the part in place.
- A bonding lug for #8 AWG wire is provided at the back. A set screw at bottom of back plate secures the wire.
- Decorative use only. More secure mounting options available but they are expensive and complicated to install—call to discuss.
- The water arc is fairly stable and not overly susceptible to change if the spout is plumbed with a smaller pipe. Replace the provided male adapter with a bushing to fit your pipe. It's obviously not possible to move as much water with a smaller pipe. Also, the flows will not match the ones listed on the flow chart
- Designed to be removable. Provided it's installed in a way that allows for this. .
- The baffle ( the flat plate inside the spout) is removable. The spout is so short that without a baffle it would be possible to see inside the pipe used to plumb the spout. However, if you need to move a large amount of water and the baffle is a hindrance, remove it by unscrewing the two screws holding it in place.
What's provided
- durable bronze casting
- threaded with 1½ in NPT
- two screw bosses with ¼-20 thread
- bonding lug for #8 AWG wire
- installation instructions
- PVC male adapter fitting
- hex wrench for bonding lug
- a lot of love ❤